
This file gives instructions for installing the HPDI32 Windows 4.0 device
driver under Windows XP along with instructions for verifying that it has
been installed.

The driver executable does not contain a version resource so no version
number is available via the file's properties. The driver release is
version stamped as "19991011". The driver executable (HPDIDriver.sys)
has a modification date of June 28, 1999.


A. DISABLE THE HPDI32 DEVICES

Perform the following steps to disable teh HPDI32 devices to be
accessed via the HPDI32 NT 4.0 device driver.

1. Select the "Start" system menu, the "Settings" submenu, then the "Control Panel" submenu.
	This should bring up the "Control Panel" window.

2. From the "Control Panel" window, double click the "System" icon.
	This should bring up the "System Properties" window.

3. From the "System Properties" window select the "Hardware" tab.

4. From the "Hardware" tab, click the "Device Manager" button.
	This should bring up the "Device manager" window.

5. From the "Device Manager" window locate the HPDI32 devices.
	They should be listed under the "Other devices" category
	as "Other PCI Bridge Device".

6. For each such device, right click on the device entry, then select the
	"Disable" menu option that appears.


B. INSTALL THE DRIVER

Perform the following steps to install the HPDI32 NT 4.0 device driver.

1. Run the self extracting archive file named "HPDI.EXE".
	A "WinZip Self-Extractor" window should appear.

2. In the "WinZip Self-Extractor" window Select a suitable
	destination for the extracted content, such as
	C:\temp\hpdi32, then click the "Unzip" button.

3. A popup window should report "18 file(s) unzipped successfully".
	Click the "OK" button to dismiss the popup window.
	Click the "Close" button to dismiss the upzip window.

4. Proceed to the above specified destination directory and execute the
	installer file, which is named "Setup.exe".

5. Follow the prompts given by the installer. Upon completion, either select
	the option to reboot the PC or reboot it yourself.

6. After rebooting driver installation should be complete.


C. INSTALL VERIFICATION

Perform the following steps to verify that the HPDI32 NT 4.0
device driver is installed and running.

1. Open the "Device Manager" as described in previous steps.

2. From the "Device Manager" window select the "View" menu, then select
	the "Show hidden devices" submenu.

3. From the device list, locate the "Non-Plug and Play Drivers"
	category and expand the category list by clicking the
	"+" to the left of the category icon.

4. The HPDI32 NT 4.0 driver should be listed as "HPDIDriver".

5. The icon at the left of the "HPDIDriver" entry should be
	displayed without any modifiers to indicate that there
	are no problems.

